Reusing Computer Controlled Parts From a 305 in a 350
Thread Starter
Junior Member
Joined: May 2011
Posts: 10
Likes: 0
From: Metiskow, Alberta
Car: '83 Trans Am
Engine: 305 soon to be Vortec 350
Transmission: 700r4 (until it craps out)
Axle/Gears: open 3.23
Reusing Computer Controlled Parts From a 305 in a 350
Hi everybody I have been reading through here for a bit and have a question regarding an engine swap I am about to do. I purchased a 1986 chevy suburban 3/4 ton 4 speed with a 2 bbl. I have an 83 trans am with a computer controlled qjet. In order to save money I was planning in taking the computer distributor, carb, o2 sensor and intake from the 305 and putting it on the 350 as a stopgap measure. Would this work? Any advice on this would be appreciated.
Thanks,
Chris
Thanks,
Chris
Moderator
Joined: Jan 2000
Posts: 20,981
Likes: 11
From: Mercedes Norte, Heredia, Costa Rica
Car: 1984 Z28 Hardtop
Engine: 383 Carb
Transmission: 4L60
Axle/Gears: 3.54 Dana 44
Re: Reusing Computer Controlled Parts From a 305 in a 350
Everything will work just fine.
Thread Starter
Junior Member
Joined: May 2011
Posts: 10
Likes: 0
From: Metiskow, Alberta
Car: '83 Trans Am
Engine: 305 soon to be Vortec 350
Transmission: 700r4 (until it craps out)
Axle/Gears: open 3.23
Re: Reusing Computer Controlled Parts From a 305 in a 350
Many thanks for the quick and simple reply.
Thread
Thread Starter
Forum
Replies
Last Post
9192camaro
Engine/Drivetrain/Suspension Parts for Sale
16
Feb 3, 2019 12:21 AM
