350 Timing
Thread Starter
Junior Member
iTrader: (1)
Joined: May 2011
Posts: 44
Likes: 0
From: Waller,TX.
Car: 1984 Z28 HO
Engine: GMPP 350 HO
Transmission: 700R4 w/TCI streetfighter kit
Axle/Gears: 3.73 28 spline Eaton posi
350 Timing
Hey all . Been a while since I was here .
I am back to working on my car and had a timing question . Is it possible to be one tooth off on the distributor and still get it to run ? It just seems like the terminal block on the dist.cap is rotated to far towards the firewall to get the timing set . Thanks for the help
I am back to working on my car and had a timing question . Is it possible to be one tooth off on the distributor and still get it to run ? It just seems like the terminal block on the dist.cap is rotated to far towards the firewall to get the timing set . Thanks for the help
Joined: Oct 2001
Posts: 12,214
Likes: 1,140
From: Il
Car: 1989-92 FORMULA350 305 92 Hawkclone
Engine: 4++,350 & 305 CIs
Transmission: 700R4 4800 vig 18th700R4 t56 ZF6 T5
Axle/Gears: 3.70 9"ford alum chunk,dana44,9bolt
Re: 350 Timing
Yup.