I've just installed Edelbrock TES headers on my Camaro...The problem changing spark plugs. I 've been able to replace all 7 spark plugs except of #1. After tigtening #1, I cant seem to get the socket out because of the header...the only solution was to loosen the header to get the socket out...Any suggestions???

Use a wrench.

------------------
82 Camaro:
350, Erson cam, ported heads, Crane Hi-6 ignition, Accel supercoil, Comp Cams 1.6:1 rocker arms, TH350 tranny with 2500 stall.
SLP 1 3/4" headers

I ground down a hex end spark plug socket about 1/4" (grind a little then check it) to make all of them easier to get to. A wrench might also work. use a 3/8 or 1/4" drive socket too.

Thanks for the tip...