a good set up for a 3.1 V6
Thread Starter
Member
Joined: Aug 2004
Posts: 109
Likes: 0
From: kent England
Car: 92 firebird
Engine: 3.1 V6
Transmission: 5 speed manual
Axle/Gears: t5 and standary rear end
a good set up for a 3.1 V6
just to let you know iv had a new exhaust system fitted, my car is a 92 3.1 V6 bird, the system started off with factory headers, factory Y pipe (no more cat 
) then 2.5" mild steel back and over the axel in to a flowmaster (not sure what series) then out with 2X 3" stainless slash cuts. i found this to sound nice on idle and nice up to around 2500 rpm but anything over that sounded crap. since then i added a glasspack resonator in the position the cat used to be and it sounds very nice indeed ( not so loud anymore), also has alot more power especialy over 4000 rpm.
Nick
) then 2.5" mild steel back and over the axel in to a flowmaster (not sure what series) then out with 2X 3" stainless slash cuts. i found this to sound nice on idle and nice up to around 2500 rpm but anything over that sounded crap. since then i added a glasspack resonator in the position the cat used to be and it sounds very nice indeed ( not so loud anymore), also has alot more power especialy over 4000 rpm. Nick
Thread
Thread Starter
Forum
Replies
Last Post
Navy8125
Engine/Drivetrain/Suspension Parts for Sale
10
Aug 22, 2015 07:13 PM