ID these headers?
Thread Starter
Joined: Jun 2005
Posts: 8,122
Likes: 362
From: NC
Car: 91 Trans Am
ID these headers?
1.5 OD primaries
3" x 5" Collectors
1/16" thick steel
Not equal length
Only markings are on the flanges
"Mr Gasket"
Drivers side is 1 piece
Pass is 2 pieces #2 primary is sectioned
They were supposed to be 1 5/8" hedman LT's but I cant find any that look like them
What they really are is not that important
Im wondering how the small primaries will work with this set of heads http://cgi.ebay.com/ebaymotors/ALUMI...QQcmdZViewItem
Moderately ported TPI with ported SLP runners, moderate cam and a 150 shot
3" x 5" Collectors
1/16" thick steel
Not equal length
Only markings are on the flanges
"Mr Gasket"
Drivers side is 1 piece
Pass is 2 pieces #2 primary is sectioned
They were supposed to be 1 5/8" hedman LT's but I cant find any that look like them
What they really are is not that important
Im wondering how the small primaries will work with this set of heads http://cgi.ebay.com/ebaymotors/ALUMI...QQcmdZViewItem
Moderately ported TPI with ported SLP runners, moderate cam and a 150 shot
Joined: Aug 2006
Posts: 12,812
Likes: 110
From: Central NJ
Car: 86 Trans Am
Engine: 408 stroker sbc
Transmission: TKO600
Axle/Gears: Moser full floater m9, 3:70 trutrac
Re: ID these headers?
they do look like the hedmans, i think they made them with 1.5 tubes as well
Thread
Thread Starter
Forum
Replies
Last Post
redformula88
Engine/Drivetrain/Suspension Parts for Sale
2
Oct 14, 2015 06:08 PM
