Exhaust problems need help
Thread Starter
Junior Member
Joined: Nov 2008
Posts: 6
Likes: 0
From: Denton,Tx
Car: 1984 Z28
Engine: 350
Transmission: T-5
Exhaust problems need help
So I just bought a 1984 Z28 not too long ago and I finally put my engine in it. The engine has a seven quart Moroso pop out oil pan and I'm afraid that the exhaust is going to fry the oil in the pan since it sits so close to the oil pan. I'm pretty sure I can't run it straight back because the slave cylinder is in the way on the other side. Is there any suggestions some of you could give me?
Joined: Mar 2000
Posts: 43,187
Likes: 42
From: Littleton, CO USA
Car: 82 Berlinetta/57 Bel Air
Engine: L92/LQ4 (both w/4" stroke)
Transmission: 4L80E/4L80E
Axle/Gears: 12B-3.73/9"-3.89
Welcome aboard thirdgen.org.
The best suggestion I have is to use a standard oil pan and a quality synthetic oil (Mobil 1, AMSOIL, Red Line, etc. - NOT QS, Pennsoil, Vavoline, etc.).
The best suggestion I have is to use a standard oil pan and a quality synthetic oil (Mobil 1, AMSOIL, Red Line, etc. - NOT QS, Pennsoil, Vavoline, etc.).
Joined: May 2004
Posts: 5,337
Likes: 71
From: Lexington, SC
Car: 1987 SC/1985 TA
Engine: 350/vortec/fitech
Transmission: T56
Axle/Gears: 3.27 9-bolt
Re: Exhaust problems need help
I bought a standard pan to replace one of those 7-quart moroso pans for a motor last week. Cost about $40. Figure about 5 oil changes and I'll have made my money back. 
Thread
Thread Starter
Forum
Replies
Last Post
Street Lethal
Power Adders
634
Apr 30, 2019 12:14 PM
