What manifold do i need.
Thread Starter
Junior Member
iTrader: (1)
Joined: Nov 2005
Posts: 71
Likes: 1
From: Parma, oh
Car: 2012 Impala ltz 1988 Gta project
What manifold do i need.
I am getting ready to drop a temporary motor into my car. I will be doing an ls swap and am just trying to get the car drivable to get body work and chassis work done. Car had a 305 tpi from the factory and the motor i am dropping in is a 305 carbed motor. Was wondering what would be the correct manifolds so i could hook into the factory y pipe. Car is an 88 gta. Trying to do this as cheap as possible since all these parts are throw away.
Supreme Member
Joined: Oct 2004
Posts: 4,528
Likes: 240
From: Henrietta NY
Car: 1984 Trans Am L69
Engine: Sniper EFI Powered 355
Transmission: WC T5 w/ Steel Support Plate
Axle/Gears: 3.42 10 Bolt Posi
Re: What manifold do i need.
Factory TPI manifolds should work just fine.
Joined: Sep 2005
Posts: 27,899
Likes: 2,436
Car: Yes
Engine: Usually
Transmission: Sometimes
Axle/Gears: Behind me somewhere
Re: What manifold do i need.
Yup... that'd be the best bet.
Shouldn't be too hard to pick up a set from the classifieds on this site.
Shouldn't be too hard to pick up a set from the classifieds on this site.