Intermediate Pipe & Thermo Tec Insulating Wrap
Thread Starter
Joined: Oct 2014
Posts: 751
Likes: 112
Car: 1984 Z28
Engine: 305 HO
Transmission: 5 Speed
Axle/Gears: 3.23 Truetrac; was better w/ 3.73
Intermediate Pipe & Thermo Tec Insulating Wrap
Any reason I should not do this? Attempt to keep floor pan cooler, in particular along driveshaft tunnel next to rear passenger foot well.
Did not have enough to insulate up to cat. Therefore, sheet metal still getting hot.
Will finish up to the cat heat shield if no one warns against it.
Am also insulating the interior floor with Dynamat Dynaliner. It works well but would prefer added benefit of keeping sheet metal cooler.
Did not have enough to insulate up to cat. Therefore, sheet metal still getting hot.
Will finish up to the cat heat shield if no one warns against it.
Am also insulating the interior floor with Dynamat Dynaliner. It works well but would prefer added benefit of keeping sheet metal cooler.
Joined: Mar 2014
Posts: 4,557
Likes: 817
From: South Ms
Car: 89 Firebird
Engine: 355 TBI
Transmission: 700R4
Axle/Gears: 10 Bolt.Posi-3.73s
Re: Intermediate Pipe & Thermo Tec Insulating Wrap
Thinking of doing the same when I do my engine swap. Good idea.
Thread
Thread Starter
Forum
Replies
Last Post
WheelsUp84z
Engine/Drivetrain/Suspension Parts for Sale
9
Aug 12, 2011 09:08 PM
'91 Formula
Engine/Drivetrain/Suspension Parts for Sale
1
Mar 14, 2007 08:15 PM