Patching a crunch...
Thread Starter
Junior Member
Joined: Apr 2007
Posts: 9
Likes: 0
From: north Georgia
Car: '89 IROC
Engine: 305 TPI
Transmission: 700R4
Axle/Gears: 3.23 posi disc going in soon...
Patching a crunch...
IROC vs. Buick Rendevous...
1989 IROC, took a hit in the driver's quarter, still need:
one 16" REAR IROC wheel - 87-style single-groove, argent gray paint
stock panhard bar - checking local 'yard Monday - if I strike out, calling Thomas
driver's side spoiler extension - *THANKS rrat227
might need ground effect extension, too - mine is good, don't have to replace
door moulding/bump strip - are good used available, or does anyone know a source for new?
**UPDATE - I went to the Super Chevy Show in Atlanta this weekend, wandered through a couple acres of swap meet. I saw at least two of EVERY Z28/IROC wheel ever put on a third-gen - EXCEPT the '85-'87 style!
(There was not a SINGLE third-gen in the car show there AT ALL. 1st and 4ths everywhere, good selection of late-2nds, NO 3rds - except for a handful on the track...)
Does ANYONE out there have one stray, gray-paint '87-style rear IROC wheel?
If not, will consider pair or set - if I can afford them. :-)
1989 IROC, took a hit in the driver's quarter, still need:
one 16" REAR IROC wheel - 87-style single-groove, argent gray paint
stock panhard bar - checking local 'yard Monday - if I strike out, calling Thomas
driver's side spoiler extension - *THANKS rrat227
might need ground effect extension, too - mine is good, don't have to replace
door moulding/bump strip - are good used available, or does anyone know a source for new?
**UPDATE - I went to the Super Chevy Show in Atlanta this weekend, wandered through a couple acres of swap meet. I saw at least two of EVERY Z28/IROC wheel ever put on a third-gen - EXCEPT the '85-'87 style!
(There was not a SINGLE third-gen in the car show there AT ALL. 1st and 4ths everywhere, good selection of late-2nds, NO 3rds - except for a handful on the track...)
Does ANYONE out there have one stray, gray-paint '87-style rear IROC wheel?
If not, will consider pair or set - if I can afford them. :-)
Last edited by sidetrack; Jun 3, 2007 at 09:29 PM. Reason: UPDATE
Member
iTrader: (8)
Joined: Dec 2001
Posts: 370
Likes: 0
From: Simi Valley, CA USA
Car: 87' Pont GTA
Engine: 5.7L
Transmission: 700R4
Re: Patching a crunch...
I have the Rear Spoiller Left Side Piece and Rear Quarter Extention for $25.00 each plus shipping and handling. I should also have the Stock Pan Hard Rod for $20.00 plus shipping and handling. If you have any questions or other needs we can be reached at (818) 700-7970.
Thank you,
Thomas R. ***
(818) 700-7970
www.houseofcamaro.com
Thank you,
Thomas R. ***
(818) 700-7970
www.houseofcamaro.com
Thread
Thread Starter
Forum
Replies
Last Post
Xenodrgn
Tech / General Engine
1
Apr 25, 2001 09:36 PM
crazeinc
Suspension and Chassis
3
Feb 14, 2001 09:03 AM
