important warning!
#1
Supreme Member
Thread Starter
iTrader: (1)
Join Date: May 2004
Location: houston
Posts: 2,262
Likes: 0
Received 0 Likes
on
0 Posts
Car: 83 POS monte carlo 2015 chevy P/U
Engine: 92 5.7 tpi 5.3
Transmission: 700r4 6L60E
Axle/Gears: 2.42 too high
important warning!
i just ran across this and im not sure where this should go, i feel the fabrication section is probably the best place.
i think everyone needs to know about it.
http://www.brewracingframes.com/id75.htm
i think everyone needs to know about it.
http://www.brewracingframes.com/id75.htm
#2
Supreme Member
iTrader: (2)
Join Date: Dec 2000
Location: Buffalo, NY
Posts: 2,361
Likes: 0
Received 2 Likes
on
1 Post
Car: 1984 Trans Am
Engine: LT1
Transmission: T56
Axle/Gears: 10 bolt w/ 4.10 gears
Re: important warning!
I read that on another message board and agree it's important for people to read if they do any welding or fabricating in general. Smart move posting it up here
Thread
Thread Starter
Forum
Replies
Last Post
ZZ3Astro
Power Adders
1045
08-13-2019 12:57 AM
IROCZDAVE (88-L98)
Engine/Drivetrain/Suspension Parts for Sale
0
09-02-2015 08:43 AM