feel free to copy this.
Thread Starter
Junior Member
Joined: Apr 2009
Posts: 72
Likes: 0
From: hillsboro aka hillsburito Oregon
Car: 83 berlinetta
Engine: 305 roller motor
Transmission: th350
Axle/Gears: 10 bolt 3.08
feel free to copy this.
I made this cross member and torque arm bracket for my th350 just thought I'd share I like it when I make it myself and I am sure some of you do also.
Joined: Aug 2006
Posts: 12,812
Likes: 109
From: Central NJ
Car: 86 Trans Am
Engine: 408 stroker sbc
Transmission: TKO600
Axle/Gears: Moser full floater m9, 3:70 trutrac
Re: feel free to copy this.
hard to tell what im looking at in that pic, but if it works and the welds are good, its a good deal. Homemade stuff is always neat
Moderator
Joined: Jul 1999
Posts: 17,268
Likes: 170
From: 51°N 114°W, 3500'
Car: 87 IROC L98
Engine: 588 Alcohol BBC
Transmission: Powerglide
Axle/Gears: Ford 9"/31 spline spool/4.86
Re: feel free to copy this.
It's not pretty but if it works for you, then go ahead and use it. I also have a custom made tranny crossmember for my powerglide but I don't need a torque arm bracket. I do however have a driveshaft loop built into it.
Sort of similar design. Some angle iron bolted to the body but instead of square tubing joining the angle iron, I have two 1" round tubes with the tranny mount between them.
With a bit of fabrication skills, it's not hard to make a tranny crossmember. Just make sure the output shaft is close to the original height.
Sort of similar design. Some angle iron bolted to the body but instead of square tubing joining the angle iron, I have two 1" round tubes with the tranny mount between them.
With a bit of fabrication skills, it's not hard to make a tranny crossmember. Just make sure the output shaft is close to the original height.
Thread
Thread Starter
Forum
Replies
Last Post
Hotrodboba400
Firebirds for Sale
3
Dec 10, 2019 07:07 PM
dbrochard
Engine/Drivetrain/Suspension Parts for Sale
6
Sep 19, 2015 08:13 PM
Hotrodboba400
Firebirds for Sale
0
Sep 2, 2015 07:28 PM
