build sheet
build sheet
where is it located in the car? i cant find one in my 92 z28
------------------
92 z28 170,000 miles 14.20 on goodyear eagles before exhaust only mods k&n and slp 13/4 headers and dual 2 1/2 exhaust
87 trans am 12.20 on motor too many mods to list
------------------
92 z28 170,000 miles 14.20 on goodyear eagles before exhaust only mods k&n and slp 13/4 headers and dual 2 1/2 exhaust
87 trans am 12.20 on motor too many mods to list
I found one under the drivers seat and one under the rear bumper cover on my Camaro.
------------------
'86 Camaro Sport Coupe
------------------
'86 Camaro Sport Coupe
It was between the metal webing and the foam underneath the seat bottom. It had been tucked up in there. BTW, the information on the two build sheets covered different areas of my car.
I bought a '89 and '91 new, the build sheet was just thrown in the car along with sub-assembly build sheets, I also had a '82 Indy, I found the sheet under the passenger side seat (It did not match the VIN) and a '83 Z28 that sheet was under the driver seat, those cars were all built in Van Nuys, my '87 Convertible was built in Norwood, and I had the complete interior out and I could'nt find a build sheet in it. Chris
Supreme Member
Joined: Jan 2001
Posts: 1,236
Likes: 0
From: Brockton, MA, USA
Car: 1983 Z28
Engine: 6.6L 406
Transmission: T-56
I haven't checked the seats but I gutted my whole interior and I never found anything. I am still going to check the bumper cover and on top of the gas tank
------------------
I WOULD RATHER PUSH A CAMARO THAN DRIVE AN IMPORT
1983Z28 350w/ edelbrock performer RPM power package , dynomax shorty headers, 700R-4 with shift kit, 750cfm carb, edelbrock 3" exhaust system, ASCD SS hood, 16" IROC rims.
future mods:
completely done over suspension, black paint with flames, Hurst shifter, dakota digital gauge package, procharger supercharger.
------------------
I WOULD RATHER PUSH A CAMARO THAN DRIVE AN IMPORT
1983Z28 350w/ edelbrock performer RPM power package , dynomax shorty headers, 700R-4 with shift kit, 750cfm carb, edelbrock 3" exhaust system, ASCD SS hood, 16" IROC rims.
future mods:
completely done over suspension, black paint with flames, Hurst shifter, dakota digital gauge package, procharger supercharger.
Trending Topics
Member
Joined: Jul 1999
Posts: 188
Likes: 0
From: Arlington,Texas,USA
Car: 1991 Z28 1LE
Engine: 305
Transmission: 5 Speed
Don't be disappointed if you can't find it-
many cars left the assembly line without one.
Gregg
http://www.1le.org
many cars left the assembly line without one.
Gregg
http://www.1le.org
Thread
Thread Starter
Forum
Replies
Last Post





