Door Decals
Thread Starter
Junior Member
Joined: Oct 2004
Posts: 29
Likes: 0
From: Iowa
Car: 89 IROC
Engine: 350 TPI
Transmission: 700R4
Door Decals
I have an 89 IROC that I just had repainted. The decals are on the center of the bottom half of the door, which I said is wrong. Since I had the decals made for $30 I was not going to argue with the man, but I know it isn't right. Does anyone know the exact place that the decals are suppossed to be located at?
Thanks
Chris
Thanks
Chris
Moderator
Joined: Mar 2001
Posts: 14,298
Likes: 197
From: Doghouse ······································ Car: 1989 Formula 350 Vert Engine: 350 L98 Transmission: 700R4 Axle/Gears: B&W 3.27
Car: 87 Formula T-Top, 87 Formula HT
Engine: 5.1L TPI, 5.0L TPI
Transmission: 700R4, M5
Axle/Gears: Sag 3.73, B&W 3.45
I from 85-87 they were located forward on the door, 88-90 they were on the rear of the door (if equiped)
Thread Starter
Junior Member
Joined: Oct 2004
Posts: 29
Likes: 0
From: Iowa
Car: 89 IROC
Engine: 350 TPI
Transmission: 700R4
Thanks for the response guys. I knew that I was right on that one. But does anyone know the exact measurements from the edge of the rear of the door, and also from the bottom of the door that I can go off of? That would help so I can place them in the correct spot.
Thanks
Chris Diedrick
Thanks
Chris Diedrick
Senior Member
iTrader: (2)
Joined: Feb 2004
Posts: 697
Likes: 1
From: Kalamazoo
Car: 89 iroc
Engine: 355 TPI FINALLY
Transmission: 700r4/ SHIFT KIT
Axle/Gears: 3.42
here are the dims of the decals
from the edge of door to the bottom of the I is 3 1/4
bottom of the door to the bottom of decal is 6 1/4
and the decal is 2 1/4 X 25 1/4
not sure if this will work...
from the edge of door to the bottom of the I is 3 1/4
bottom of the door to the bottom of decal is 6 1/4
and the decal is 2 1/4 X 25 1/4
not sure if this will work...
Last edited by gscz28; Mar 22, 2006 at 09:42 AM.
Thread Starter
Junior Member
Joined: Oct 2004
Posts: 29
Likes: 0
From: Iowa
Car: 89 IROC
Engine: 350 TPI
Transmission: 700R4
Thanks again for the info, that is a start, I guess my only other question is how far from the edge of the door is the I in IROC. As in from the quarter panel edge of the door. That is the only other thing that I need to know in order to get my decals in the correct location.
Thanks
Chris Diedrick
Thanks
Chris Diedrick
Thread
Thread Starter
Forum
Replies
Last Post