Firebird Console Lid
Thread Starter
Member
iTrader: (2)
Joined: Apr 2007
Posts: 165
Likes: 1
From: Odessa, FL
Car: 1990 Firebird
Firebird Console Lid
Center console lid. The plastic bottom condition doesn't matter. I have a very nice one to swap. The top needs to be very nice. No elbow imprints, no separation, no deep scratches, no pitting, etc. Metal arm should be tight and intact. Thanks. Have Paypal. Shipping to 34986.
Joined: Aug 1999
Posts: 5,276
Likes: 469
From: RI
Car: 1984 Camaro Berlinetta
Engine: LT1
Transmission: T56 6-speed
Axle/Gears: 4.11 LS1 Rear End
Re: Firebird Console Lid
I've got this one available; $45 + shipping.
It's in real good used condition, has both hindges and the swing "arm" is still attached. (It wiggles in place a little, but I can hold the metal arm and swing the console pad around without it getting any looser or falling off ) There is a small section of the underside plastic thats chipped off (see pic ) but it does not effect opperation or show in any way once installed.
USPS parcel Post ( insured ): $14.00
USPS Priority mail ( insured ): $18.50
If your interested just send me a PM.
P.S. I could use the hinges & would like to keep them if you don't need them !
It's in real good used condition, has both hindges and the swing "arm" is still attached. (It wiggles in place a little, but I can hold the metal arm and swing the console pad around without it getting any looser or falling off ) There is a small section of the underside plastic thats chipped off (see pic ) but it does not effect opperation or show in any way once installed.
USPS parcel Post ( insured ): $14.00
USPS Priority mail ( insured ): $18.50
If your interested just send me a PM.
P.S. I could use the hinges & would like to keep them if you don't need them !
Thread
Thread Starter
Forum
Replies
Last Post
1992 Trans Am
History / Originality
27
May 10, 2023 07:19 PM
