I just put all new soft seal weatherstripping on my doors and roof rail. When i put the new stripping on my doors and test colsed them i couldn't really get the door closed with out really shutting it hard or giving it a good bump. Then i put the roof rail stripping on and it's even worse. My window wont roll down from the inside because of all the pressure from the stripping pushing against it.

Is there a way to adjust the window to bring it out some so there isn't so much pressure against it?

 

Which weatherstrips did you buy?

 

Have you adjusted your door striker? How about hinge pins and bushings? If the door fit well before with the old crushed and worn out weatherstrip, then the new ones will fit tight.

 

i got the metro kit its both doors and the hatch and for about a week or two i could barely shut my doors but its fine now shuts perfect

 

it says in his post "soft seal" so Im guessing its the weatherstip from Soff Seal...I havent bought anything from them but Ive read on the boards that weatherstipping from GM is the only way to go...

 

thats true but at half the cost i got my metro seals and i have no complaints only that the molded caps on the ends are not even close to oem