Is This Factory?
Thread Starter
Supreme Member
Joined: Apr 2008
Posts: 2,342
Likes: 24
From: Dumfries, VA
Car: 1985 Z28
Engine: 334 Stroker Superram 222/230
Transmission: Full Manual 700R4 / 3k Street Edge
Axle/Gears: 3.90 Eaton, Moser, Richmond & More
Is This Factory?
I've always wondered. On my console in the little valley where the E-Brake rests, there is a small hole going through the console. It does not appear to be sloppily drilled so I was just wondering is this factory as it doesn't appear to serve any purpose.
Joined: Jul 2002
Posts: 1,983
Likes: 6
From: Stamford, New York
Car: 80 SE/TTA;88 T/A GTA;86 T/A
Engine: 4.9L Turbo; LT1; empty
Transmission: TH350; T56; empty
Axle/Gears: 3:23 disk; 4:10 disk ; 3.42 disk
Re: Is This Factory?
I would have to say no, no holes exist on any of the cars i've taken apart or owned.
Joined: Jul 2006
Posts: 1,287
Likes: 523
From: Rochester NY
Car: 1984 TA (1 stock / 1 custom)
Engine: LG4 / turbo LQ4
Transmission: 700R4 / 4L80E
Axle/Gears: Stock / 3:50 Moser 9"
Re: Is This Factory?
can you post a picture? on my '84 TA there is a torx head screw under the e-brake that holds the console top to the base. not sure if this is the hole you're talking about.
Thread Starter
Supreme Member
Joined: Apr 2008
Posts: 2,342
Likes: 24
From: Dumfries, VA
Car: 1985 Z28
Engine: 334 Stroker Superram 222/230
Transmission: Full Manual 700R4 / 3k Street Edge
Axle/Gears: 3.90 Eaton, Moser, Richmond & More
Re: Is This Factory?
It was nor factory. You can see on the backside where a drill went through.
The console is out cause I'm restoring the interior. So I just filled the hole with bondo before painting the console.
Wonder what the heck he used it for
The console is out cause I'm restoring the interior. So I just filled the hole with bondo before painting the console.
Wonder what the heck he used it for
Thread
Thread Starter
Forum
Replies
Last Post