Bright light switch wont engage brights.
#1
Member
Thread Starter
Bright light switch wont engage brights.
I cant quite figure it out, but in order to turn my bright lights on I have to completely tilt the steering wheel clear to the bottom and then pull back on the lever to engage my brights.When I want to disengage my brights however all I do is pull back the stick and no matter where the steering wheel is tilted my brights disengage...any ideas or ways to fix this? Thanks guys!
Last edited by LoganKello; 01-19-2011 at 12:49 PM.
#2
Moderator
iTrader: (5)
Re: Bright light switch wont engage brights.
I cant quite figure it out, but in order to turn my bright lights on I have to completely tilt the steering wheel clear to the bottom and then pull back on the lever to engage my brights.When I want to disengage my brights however all I do is pull back the stick and no matter where the steering wheel is tilted by brights disengage...any ideas or ways to fix this
JamesC
#3
Supreme Member
Join Date: Sep 2002
Location: Cary, North Carolina
Posts: 9,192
Likes: 0
Received 16 Likes
on
16 Posts
Car: 1992 RS
Engine: Carbed 350
Transmission: 700R4
Axle/Gears: 3.42 posi
Re: Bright light switch wont engage brights.
The actual switch is at the bottom of the column above the brake pedal. There are two small screws that hold it on. Move the lever and you can see the rod moving in/out of the switch. Loosen those screws, and adjust the switch up/down the column, then retighten screws. Set you tilt wheel where you normally drive before adjusting - it's impossible to adjust the switch where it works at all tilt settings.
Thread
Thread Starter
Forum
Replies
Last Post
ambainb
Camaros for Sale
11
04-25-2016 09:21 PM
Pilotrick50
Interior Parts for Sale
1
09-02-2015 12:48 PM