Firebird map/cup holder reinforcements?
Thread Starter
Joined: Jul 2005
Posts: 225
Likes: 3
Car: 1989 Iroc convertible
Engine: 305
Transmission: T5
Axle/Gears: 3.08 posi
Firebird map/cup holder reinforcements?
So I just ebayed myself a set of cup holder/map pocket door things. They were Oem off of 91 bird. Look to be in great shape which is a plus. But have questions. I know most say they break easy, but what actually breaks? Where? I ask because before I install I would like to see if I can reinforce the weak area. No idea how yet. Any input?
Supreme Member
Joined: May 2005
Posts: 2,220
Likes: 68
From: Atlanta
Car: '02 T/A WS6, '91 T/A, '91 Camaro RS
Engine: LS1, LB9, L03
Transmission: T56, 700R4, 700R4
Axle/Gears: 4.10 10 bolt, 2.73 10 bolts
Re: Firebird map/cup holder reinforcements?
It's usually the mounting points that break -- the plastic around where the screws go.
Senior Member
iTrader: (1)
Joined: Jan 2008
Posts: 618
Likes: 12
From: Destin, Florida
Car: 91 Trans Am Convertible
Engine: LB9 5.0 TPI
Transmission: 5 SPD
Axle/Gears: Posi Rear
Re: Firebird map/cup holder reinforcements?
Usually the middle mouning screw support behind the little cap over the screw hole is the first to go but all three mounting holes are a weak design. I have tried to reinforce them but now I just use extreme care when working around them. A poorly placed hand when getting under the dash or a wayward foot kick when exiting the vehicle are the ones that hurt.
Thread
Thread Starter
Forum
Replies
Last Post
1Aauto
Sponsored Vendors
0
Sep 2, 2015 01:35 PM
