Beechwood Passenger Seat Belt Retractor
Thread Starter
Joined: Oct 2011
Posts: 475
Likes: 8
From: Houston, TX
Car: 1989 GTA, 2004 Z06, 2008 Expedition
Engine: L98, LS3, 5.4L
Transmission: 700R4, MN6, Auto
Axle/Gears: 3.23, 3.42, ?
Beechwood Passenger Seat Belt Retractor
hey everyone, the tabs are broken on the top plastic cover for my passenger seatbelt. The car is an '89 GTA T-Top car with the beechwood(tan) interior. If anyone can help me out it would be greatly appreciated.
Senior Member
iTrader: (1)
Joined: Dec 2012
Posts: 808
Likes: 5
From: Tucson, AZ
Car: 88 GTA Notchback
Engine: 350 TPI
Transmission: 700R4
Axle/Gears: don't know
Re: Beechwood Passenger Seat Belt Retractor
I have a beechwood interior in my car. The plastic is literally falling apart on my overhead retractors. I have found that the tan 4th gen seat belts are super super close to beachwood brown. I already have the drivers side, just waiting to procure a passenger side.
IMO the 4th gen belts are safer, and cheaper than the 3rd gens. But, if you must keep the 3rd gen there is a little screw hole in the retractor, just drive a tiny screw through the trim into the retractor.
IMO the 4th gen belts are safer, and cheaper than the 3rd gens. But, if you must keep the 3rd gen there is a little screw hole in the retractor, just drive a tiny screw through the trim into the retractor.
Senior Member
iTrader: (3)
Joined: Jan 2012
Posts: 877
Likes: 2
From: Clark NJ
Car: 1988 Pontiac Transam GTA Notchback
Engine: 2003 Chevy 5.3 Vortec (325 cu)
Transmission: 4L60E
Axle/Gears: 3.27
Re: Beechwood Passenger Seat Belt Retractor
Buy a reproduction and hit it with Fiero Beechwood paint. Even you wont tell the difference
Thread
Thread Starter
Forum
Replies
Last Post
Randomtask2
Interior Parts for Sale
5
Sep 10, 2015 08:37 AM