Twin turbo system for sale $4950. Modified by John Craig of Limit Engineering to support 1250 HP. I bought the entire vehicle drivetrain drop-out as a package, but I do not need the turbo system for what I am doing. This system is several years old but the car was in storage almost the whole time. It has low miles and wasn't even tuned before pulling apart the car.

The turbos are positioned to keep air conditioning. This is about as complete as it gets, sans a couple pipe clamps that were missing when I brought it home.

• Twin Precision T3-T4 hybrid turbos made by John Craig at Limit Engineering. T04E compressor housing, Stage 5 P-trim turbine wheel, and Stage 5 61mm compressor wheel, 0.63 exhaust housing
• Stainless headers and exhaust
• Turbosmart blowoff valve
• Turbosmart wastegates
• e-Boost 2 wastegate controller
• Alcohol injection system
• 80 lb injectors
• large air-to-air intercooler. 25"x10"x3.5" core / (x2) 2.5" inlets, (x1) 4" outlet (vertical flow)
• radiator cover to route air flow
• braided stainless steel oil lines

 

wheres the shortblock?

 

I just bought a new engine today. After it shows up I'll sell the turbo engine complete. After a while if there isn't enough interest I will part it out.

 

Still available. HKE 398 stroker coming soon.

 

Will the turbo's fit in to the 3rd gen? As I see they have to be located right on the sides of the block (where normaly headers would go down to exaust) and there is quite a tight spot there and + steering components on the driver's side.

Do you know if this setup fits in to a 3gen?

 

No, it will not. You would have to fabricate new exhaust components.

 

Thank you. Thought so...

 

Sold!