After life getting in the way too many times I am abandoning my project. Engine and trans never been in the car. Suspension installed has never seen the road. Only to do the rear end swap and get it rolling again. Parts NIB (new in box) or installed on car and are as follows. Located near Stroudsburg, PA.

I still have some of these parts but I have moved to Bryan/College Station, Texas.

• BMR-KM008R K-member w/LS1 motor mounts, factory mounts. ($550) NIB
• BMR-AA008R A-arms, lower, DOM, non-adj, poly bushings and spring pocket ($450) NIB
• BMR-RH010 Control arm hardware kit front lower only ($10) NIB
• Inline Tube SS brake line kit for rear disc ($150) NIB
• RACING INNOVATION AND SUPPLY 1982-92 LS1 THIRD GEN CHEVROLET CAMARO, PONTIAC FIREBIRD, AND PONTIAC TRANS AM LONG TUBE HEADER RIS.10051 ($330) NIB
• 99-2004 Corvette Fuel/Filter Regulator WIX33737 $30
• 2003 Escalade LQ9 w/83k ECU and e-pedal. acc pulled but still have and no oil pan, was going swap for F-Body but didn’t get around to it. Ran when I bought it but has sat since, not sure when these go for now(best offer)
• T-56 MN12 from 2004 GTO 64k w/shift adapter for thirdgen. Shifted fine, seller kept bell and hyrdro ($1500) NO BELLHOUSING or hydraulics
• moser 9" 4:10 gears tru trac 31 spline 4 channel F-Body 1982-2002 5k miles ($2000) installed.