converting OBD II to OBD I
07-30-2006, 08:34 PM
#1
Supreme Member
Thread Starter
iTrader: (3)
Join Date: May 2004
Location: Kingsport Tenn
Posts: 1,036
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1992 camaro
Engine: LT1
Transmission: 4L60E
Axle/Gears: 3:73
converting OBD II to OBD I
What is involved in converting OBD II to OBD I just the com? I did a search and nothing really detailed came up. Finally found a 97 LT1 and going to get it
07-31-2006, 12:40 AM
#2
Senior Member
iTrader: (2)
Join Date: Nov 2001
Location: AL,USA
Posts: 920
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1990 Formula
Engine: 95 LT1
Transmission: T56
Axle/Gears: Weak 7.5 with 4.10s
I believe you only have to change the PCM and knock sensor.Check at CamaroZ28.Com - FULL THROTTLE INTERNET.
07-31-2006, 03:53 PM
#3
Member
iTrader: (2)
Join Date: Aug 1999
Location: Stafford, VA
Posts: 360
Likes: 0
Received 0 Likes
on
0 Posts
Car: 2000 Corvette FRC
Engine: LS1
Transmission: M6
Take a look at madz28.com - Rev your madness to the MAX!
They advertise a service where they will take your LT1 OBD2 ECM and convert it to OBD1. A plug and play job that uses all of your OBD2 sensors. Its $250 if I remember right.
They advertise a service where they will take your LT1 OBD2 ECM and convert it to OBD1. A plug and play job that uses all of your OBD2 sensors. Its $250 if I remember right.
Thread
Thread Starter
Forum
Replies
Last Post
Thirdgen89GTA
NW Indiana and South Chicago Suburb
4
11-26-2015 11:04 PM
