if i spray starter fluid the motor starts and runs. the fuel pump kicks on and i have fuel pressure in the rail. i borrowed my friends injector noid tester (2 prongs and a led). crank the car and get no light on any injector either side. i pull out the dvom an and i have power going to the injectors. i traced the other wire all the way back to the ecm no kinks cuts or bends. anything any one can think of that would cause my ecm not to trigger the injectors?

 

ha just read that pass key shuts off the injectors not the fuel pump. so im pretty sure that is my issue. do i just wire a ignition source through a reistor to the fuel enable wire. the how to i printed said to leave this wire open. but shopkey said it needs to read a signal to enable the injectors.