lt1 swap gauge question
Thread Starter
Member
Joined: Mar 2010
Posts: 317
Likes: 2
From: Pennsylvania
Car: 86 Trans am
Engine: LG4
Transmission: T-5
Axle/Gears: 3.27 9 bolt posi
lt1 swap gauge question
Trying to get things together to start my lt1 swap. Have entire lt1 460le out of impala ss with all harnesses. Going into an 87 trans am tpi car with digital dash. What must i do to retain my digital gauges
Joined: Apr 2005
Posts: 7,736
Likes: 14
From: Not in Kansas anymore
Car: 82 Z28
Engine: 383 SP EFI/ 4150 TB
Transmission: T400
Axle/Gears: QP 9" 3.73
Thread Starter
Member
Joined: Mar 2010
Posts: 317
Likes: 2
From: Pennsylvania
Car: 86 Trans am
Engine: LG4
Transmission: T-5
Axle/Gears: 3.27 9 bolt posi
Re: lt1 swap gauge question
So is it safe to cut up my unmolested tpi harness or should i find a tbi or carb harness to use
Joined: Apr 2005
Posts: 7,736
Likes: 14
From: Not in Kansas anymore
Car: 82 Z28
Engine: 383 SP EFI/ 4150 TB
Transmission: T400
Axle/Gears: QP 9" 3.73
Re: lt1 swap gauge question
"Buy a V6 or TBI harness and modify that one as they are significantly cheaper and the sale of the SD TPI harness should net you a good chunk back
Everything V6/TBI/TPI about your old harness is being removed"
Thread Starter
Member
Joined: Mar 2010
Posts: 317
Likes: 2
From: Pennsylvania
Car: 86 Trans am
Engine: LG4
Transmission: T-5
Axle/Gears: 3.27 9 bolt posi
Re: lt1 swap gauge question
Another question the ECM harness that goes through the fender, is there anything needed off that harness or can I just remove it, I have a carb harness screwed into the bulkhead and I have a carb ECM harness down at my brothers
Thread
Thread Starter
Forum
Replies
Last Post