Carberated LSX Hood Clearance
#1
Member
Thread Starter
Join Date: Feb 2017
Location: Mercedes, Texas
Posts: 293
Likes: 0
Received 0 Likes
on
0 Posts
Engine: 305
Transmission: T5
Axle/Gears: 4:10
Carberated LSX Hood Clearance
I am weighing my options for an LSX swap and was wondering if a carberated LSX would clear the factory hood. I have my doubts, just looking for confirmation.
#2
Re: Carberated LSX Hood Clearance
Edit - most say an ls with a carburetor won't fit. One guy seems to have done it, though.
https://www.thirdgen.org/forums/ltx-...tock-hood.html
I will also throw this out there. I used a hedman ls swap kit with engine mounts and crossmember. Someone commented that my engine appeared to sit lower than other ls swaps. The right combo of engine mounts, manifold, carburetor, and air cleaner would probably fit.
https://www.thirdgen.org/forums/ltx-...tock-hood.html
I will also throw this out there. I used a hedman ls swap kit with engine mounts and crossmember. Someone commented that my engine appeared to sit lower than other ls swaps. The right combo of engine mounts, manifold, carburetor, and air cleaner would probably fit.
Last edited by johnw999; 03-18-2018 at 09:47 AM.
#3
Supporter/Moderator
iTrader: (7)
Join Date: Feb 2001
Location: Cincinnati, OH
Posts: 13,211
Likes: 0
Received 375 Likes
on
288 Posts
Car: '90 RS
Engine: 377 LSX
Transmission: Magnum T56
Re: Carberated LSX Hood Clearance
A lot will depend on the height of the intake manifold. Most lsx carb intakes are higher than traditional SBC low profile ones which makes it trickier to fit.