Pcv help
Thread Starter
Junior Member
Joined: Mar 2011
Posts: 4
Likes: 0
Pcv help
I have an 84 z28 H.O. And the guy that had it before me had put on an edelbrock intake and carb. I wanna start cleaning up the engine bay because it's kind of sloppy but I have a question about the pcv setup my passenger valve cover has a breather on it and my driver side has the valve but it is covered and the port on the carbs are covered I'm tryin to figure out how this should really be setup.. Any help? Thanks
Joined: Aug 2006
Posts: 12,807
Likes: 108
From: Central NJ
Car: 86 Trans Am
Engine: 408 stroker sbc
Transmission: TKO600
Axle/Gears: Moser full floater m9, 3:70 trutrac
Re: Pcv help
on the front of the carb there is a large tube, about 3/8 od, in the center, down low. it goes there.
Thread
Thread Starter
Forum
Replies
Last Post
Pac J
Tech / General Engine
3
May 17, 2020 10:44 AM
tyeo098
Tech / General Engine
38
Nov 30, 2015 06:27 PM
