In the process of rebuilding my car, it's a 305/700R4 swapping in a pretty hot 350/Muncie 4spd/ ford 9 inch.

Long story short got bored and put a 671 blower on it to see what it would look like! Hopefully you enjoy as much as I did haha.

 

Now you need an 18" cowl induction hood.

 

Haha yes!

 

Got my good mark 4" cowl hood to clear my set up. Looks pretty cool I like the change


Took away some visibility in drivers seat but honestly in 5'7" so I couldn't see the passenger side front anyway.


.

 

Figured id update about the car. Well since I got the hood it has pretty much only moved spots in the driveway lol, just stacking parts for the new engine which I now have, plus playing games with blocks, one was cracked in the lifter valley, another needed $1500 of work, another pitted, the last one had gouge marks in the bores. Well finally found a clean block in the garage that just needs a hone and it's good. Ordered these yesterday: http://www.jegs.com/i/ProMaxx-Performance/723/9201A/10002/-1 to replace my sportsman 2's. Will completely go through these and port + polish if needed. Check those out, they flow better than equivalent Brodix heads. Since I got the itch I moved the car and started cleaning the engine bay and sanding for paint, thing was atrocious from sitting under a tree for many many years.

I love how purple power took off the paint on the firewall hehe. Wish I took a before and after, can't believe the stuff that came out. Still not pretty but it takes time cleaning 25+ years of grime, cause I'm sure nobody cleaned it lol.