Hello All!

I recently purchased a "new" but old 85 T/A front bumper cover for cheap ($85). It is an aftermarket with a CAPA sticker and it has never been mounted or painted.

I have a question:

The BC has been sitting for years and is slightly deformed. The center facing the front/outward is sunken in a little. Is there a way to address this? Or will it take shape once it is installed? The BC seems to be thick rubber material. its not rigid plastic...

I've read of people using a heat gun to straighten out these covers. Should I try this before I start sanding/priming?

Thanks!

 

I've read about people using panel bond adhesive and aluminum plates behind the bumper to bring it back to shape. I'd love to see a write up and photos on that process myself though.