I just bought a 89 Iroc 350 about a month ago and I'm ready to put some aftermarket in her. What shop does work in the KCMO area that wont f**k up my TPI. That's what I'm afaid of.

 

What do you think of doing the work yourself?

 

well I dont start school in Indy at LTI until Dec. and tools here are limited to basis stuff

 

If you have enough money to pay someone to do the work then you have enough money to buy the tools and do it yourself. I usually buy whatever tools I need to do the job when I need something done. The tools plus parts have always been cheaper than what it costs to have a shop do the work. Plus it is a good learning exprerience.

 

you could screw it up and do just as good as most profesional shops, yet have money in your pocket.