so this is where i am at....
so this is where i am at....
my car has been sitting and i wanna start working on it and be able to drive it. i am going lsx so i need to sell my small block chevy stuff. i wanna see if there is an interest in what i have here before i CL or ebay it. so shout out if interested.
world class t5 set up (pro 5.0 shifter, bell,clutch,flywheel, hydraulics) $650
brodix 180 iron killer heads/ matching intake ( never ran on a motor and are brand new. intake is included with the heads. $900
comp cams 274h extreme energy cam/lifters/timing chain $100
serp drive set up from 91 z28 (has ac delete included. this is everything from alternator to water pump.) $350
painted and boxed torque arm w/ bushing $100
i have a few other misc parts i wanna dump off but i need to look thru what i have.
gasket set for small block chevy 1pce rear main with rubber oil pan gasket $60
new oil pump w/ pickup $50
lemme know what you guys think
world class t5 set up (pro 5.0 shifter, bell,clutch,flywheel, hydraulics) $650
brodix 180 iron killer heads/ matching intake ( never ran on a motor and are brand new. intake is included with the heads. $900
comp cams 274h extreme energy cam/lifters/timing chain $100
serp drive set up from 91 z28 (has ac delete included. this is everything from alternator to water pump.) $350
painted and boxed torque arm w/ bushing $100
i have a few other misc parts i wanna dump off but i need to look thru what i have.
gasket set for small block chevy 1pce rear main with rubber oil pan gasket $60
new oil pump w/ pickup $50
lemme know what you guys think
Member
Joined: Nov 2007
Posts: 134
Likes: 0
From: Twin Cities, MN
Car: 83 camaro berlinetta
Engine: 40 over 350
Transmission: 86 T5
Axle/Gears: 3.73
Re: so this is where i am at....
I'm interested in the trans. I'd like to find out more about it. What state are you in? I'm looking for a T5 close to MN so I don't have to pay shipping, but I'm open to it. I'm gonna send you a message too.
Thread
Thread Starter
Forum
Replies
Last Post
paulmoore
Power Adders
3
Mar 4, 2008 08:05 AM




