Gettin ready to drop the motor in, but...
03-05-2007, 12:46 PM
#1
Supreme Member
Thread Starter
iTrader: (2)
Join Date: Feb 2006
Location: Sacramento Ca
Posts: 1,262
Likes: 0
Received 0 Likes
on
0 Posts
Car: 86 Trans am, 91 Camaro RS
Engine: 355 Sbc, nothin yet
Transmission: 700r4- both
Gettin ready to drop the motor in, but...
Should I attach the headers before i put this beast between the frame rails or wait til its already in?
03-05-2007, 01:05 PM
#3
Junior Member
Join Date: Aug 2006
Location: Lancaster, PA
Posts: 71
Likes: 0
Received 0 Likes
on
0 Posts
I got my shorties in, just barely though, with the engine in there. But I'd put them in before just to be safe.
If they're long tubes then yeah, take JesasaurusRex's advise.
If they're long tubes then yeah, take JesasaurusRex's advise.
03-05-2007, 02:42 PM
#4
Supreme Member
Join Date: May 2006
Location: Maui, Hawaii
Posts: 1,857
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1984 Trans Am
Engine: broken 385sbc
Transmission: G-Force rebuilt T-5
Axle/Gears: Currie 9" Ford 4.30:1
if you have a kickout oil pan, lay them in before hand.. if not, you can get them in there after the motor is in.. kickout pans are a BITCH!! but good for the motor
Thread
Thread Starter
Forum
Replies
Last Post
evilstuie
Tech / General Engine
22
01-09-2020 08:29 PM