YES! PASSED SMOG!
Thread Starter
Supreme Member
iTrader: (3)
Joined: May 2004
Posts: 2,233
Likes: 4
From: stockton, CA
Car: Camaro RS/SS
Engine: 5.7 LS1
Transmission: 4L60E Transgo shift kit, 3500 stall
Axle/Gears: 4th Gen Rear 3:42
YES! PASSED SMOG!
Just wanted to let you guys know that i passed my smog yesterday. I went to modesto to get it looked at by the State Ref. It took me 3 times to pass
but i finally got it. Took a lot of testing and tuning and crying LOL.. My CO% was really high ( To much gas) all because of a exhaust leak right next to my O2 sensor. LOL.. Live and learn. So my car is legal and ready for more mods and treats..... Well after the wedding.
Just wanted to let you guys know. LS1 swap is possible in CALI!!
Joey J.
but i finally got it. Took a lot of testing and tuning and crying LOL.. My CO% was really high ( To much gas) all because of a exhaust leak right next to my O2 sensor. LOL.. Live and learn. So my car is legal and ready for more mods and treats..... Well after the wedding.
Just wanted to let you guys know. LS1 swap is possible in CALI!!
Joey J.
Supreme Member
iTrader: (7)
Joined: Nov 2006
Posts: 3,740
Likes: 15
From: Alamogordo, NM
Car: 88 Formula 350
Engine: 5.7
Transmission: T-56
Axle/Gears: 9" 3.89
Re: YES! PASSED SMOG!
How much of a pita was it to get it in the car? how much was it to put it in not including the cost of the engine and how many MPG are you getting. I am thinking about putting on in my car this summer.
Thread Starter
Supreme Member
iTrader: (3)
Joined: May 2004
Posts: 2,233
Likes: 4
From: stockton, CA
Car: Camaro RS/SS
Engine: 5.7 LS1
Transmission: 4L60E Transgo shift kit, 3500 stall
Axle/Gears: 4th Gen Rear 3:42
Re: YES! PASSED SMOG!
It wasnt to bad. If i had to do again i would put the engine in first then later put in the tranny. The wiring was the hard part. Have to adapt your old harness to the new one or you can bay 1G to get a custom one for you at speartech. as far as the gas im not sure. I still need to get my speedo to work. I only drive it on the weekends. Its a pretty expensive job if your going to do it right. This is somthing that you want to take your time on and think things through
Supreme Member
Joined: Aug 2004
Posts: 4,168
Likes: 3
From: Marietta, GA
Car: '91 Firebird Convertible
Engine: 305 TBI (LO3)
Transmission: 700r4, Vette Servo
Axle/Gears: 3.27 9 Bolt, PBR disks
Thread Starter
Supreme Member
iTrader: (3)
Joined: May 2004
Posts: 2,233
Likes: 4
From: stockton, CA
Car: Camaro RS/SS
Engine: 5.7 LS1
Transmission: 4L60E Transgo shift kit, 3500 stall
Axle/Gears: 4th Gen Rear 3:42
Thread Starter
Supreme Member
iTrader: (3)
Joined: May 2004
Posts: 2,233
Likes: 4
From: stockton, CA
Car: Camaro RS/SS
Engine: 5.7 LS1
Transmission: 4L60E Transgo shift kit, 3500 stall
Axle/Gears: 4th Gen Rear 3:42
Thread
Thread Starter
Forum
Replies
Last Post






