calling xpndbl3 I need your help!!
Thread Starter
Supreme Member

Joined: Dec 2004
Posts: 1,204
Likes: 0
From: chicago IL
Car: 91 formula
Engine: 350 tuned port. bolt ons
Transmission: 700r4
Axle/Gears: 3.73
calling xpndbl3 I need your help!!
Ok im geting very pissed with my car right now. I still have that rough idel and the first shop i took it to can't find the problem and did not charge me for it. i then went to another shop and he called me up about 2 days after droping the car and said he found the problem it was the ignition coil{WRONG THE COIL WAS 2 MONTH OLD AND TESTED FINE!!!
i went over there and before i paid the bill i started the car and it was still running the same way a rough idel and hard to start. i took his coil off and put mine back on. So I was wondering if you are still willing to look at my car. I will drive it out there if i have to. I always have fri and sun off work but will call out of work to get this car running good.
i went over there and before i paid the bill i started the car and it was still running the same way a rough idel and hard to start. i took his coil off and put mine back on. So I was wondering if you are still willing to look at my car. I will drive it out there if i have to. I always have fri and sun off work but will call out of work to get this car running good.
Supreme Member
iTrader: (2)
Joined: Feb 2003
Posts: 1,583
Likes: 1
From: Chicago
Car: Only a daily driver, but comin home
Engine: I have one that runs ;)
Transmission: Caged hamster that runs really fast
Axle/Gears: They are round, I know that much
where you at?? i live on the NW side of chicago and know my way around a third gen very well.....Steve can vouch for me, call my cell at 773 844 9749, and will be available friday afternoon right after i run to the DMV, and saturday afternoon
Supreme Member
iTrader: (5)
Joined: Jan 2002
Posts: 13,622
Likes: 5
From: Orland Park, IL
Car: 1984 Z28
Engine: SLOW carbed ls
Transmission: TH400 with brake, 8" PTC converter
Axle/Gears: moser 9" 4.11
hey man, this weekend is no good for me, but next week or weekend i'll be free. Have mike give it a shot first since he's local to you, but if not feel free to stop by. I would also have someone who has a scan tool check it out, to see how the sensor values are reading. A wrong value for the TPS or map, etc etc could all cause a rough idle. I'm sure you checked simple things like timing with the EST wire disconnected as well.
Supreme Member
iTrader: (2)
Joined: Feb 2003
Posts: 1,583
Likes: 1
From: Chicago
Car: Only a daily driver, but comin home
Engine: I have one that runs ;)
Transmission: Caged hamster that runs really fast
Axle/Gears: They are round, I know that much
see you friday....and worst comes to worst.....offer steve a 12 pack and he will travel
Thread
Thread Starter
Forum
Replies
Last Post




