MW66NOVA.... Question about your car?
Thread Starter
Senior Member
iTrader: (2)
Joined: Jul 2002
Posts: 784
Likes: 1
From: Philly, PA
Car: 1986 Camaro SC
Engine: None
Transmission: None
Axle/Gears: Moser 9" W/ spool 3.50 gears
MW66NOVA.... Question about your car?
I was surfing youtube looking for Exhaust clips and I think I came across one of yours with either Dynomax or Magnaflows. But in the clip I think it stated that it wasn't your 305 or LS1. Does this sound right or am i wrong about your exhaust set up?
Can you post any clips of that? I am considering a new set up and want something that flows well and sounds like a nasty race car. Yours sounded pretty good.
Any Magnaflow or dynomax on SBC motor clips welcome!
Can you post any clips of that? I am considering a new set up and want something that flows well and sounds like a nasty race car. Yours sounded pretty good.
Any Magnaflow or dynomax on SBC motor clips welcome!
Supreme Member
iTrader: (5)
Joined: Jan 2002
Posts: 13,622
Likes: 5
From: Orland Park, IL
Car: 1984 Z28
Engine: SLOW carbed ls
Transmission: TH400 with brake, 8" PTC converter
Axle/Gears: moser 9" 4.11
Re: MW66NOVA.... Question about your car?
most definitely his 305 if it wasn't from the past few weeks IMO
Joined: Jun 2002
Posts: 13,576
Likes: 30
From: Harford County, MD
Car: camaro sportcoupe
Engine: 7.0L
Transmission: G-Force GF5R
Axle/Gears: Moser 9"
Re: MW66NOVA.... Question about your car?
lol
ls1 with 4" maggie, still on jack stands not even been driven yet:
http://www.youtube.com/watch?v=9CbOGu5x63o
ls1 with 4" maggie, 12.30 pass at the track two weeks ago:
http://s91.photobucket.com/albums/k3...=mattspass.flv
3.5" dynomax bullet single with solid cammed 350 from last summer:
http://www.youtube.com/watch?v=weBt7kK7n68
3.5" dynomax bullet with 280H cammed 305:
http://www.youtube.com/watch?v=_93-ig9Wvj4
i'm actually about to redo it again, but keeping the 4" magnaflow. i'm going to dump it under the car though. having a problem with space...i'm about to do a sumped fuel tank and don't have the room to have both the sumped tank and the muffler back there without having too much heat...
ls1 with 4" maggie, still on jack stands not even been driven yet:
http://www.youtube.com/watch?v=9CbOGu5x63o
ls1 with 4" maggie, 12.30 pass at the track two weeks ago:
http://s91.photobucket.com/albums/k3...=mattspass.flv
3.5" dynomax bullet single with solid cammed 350 from last summer:
http://www.youtube.com/watch?v=weBt7kK7n68
3.5" dynomax bullet with 280H cammed 305:
http://www.youtube.com/watch?v=_93-ig9Wvj4
i'm actually about to redo it again, but keeping the 4" magnaflow. i'm going to dump it under the car though. having a problem with space...i'm about to do a sumped fuel tank and don't have the room to have both the sumped tank and the muffler back there without having too much heat...
Last edited by mw66nova; Jul 15, 2009 at 09:02 PM.
Member
Joined: Jul 2008
Posts: 464
Likes: 0
From: BALT, MD
Car: 84 camaro
Engine: HRE 355
Transmission: th350
Axle/Gears: 4.56
Re: MW66NOVA.... Question about your car?
hey matt..that ls1 sounds really nice in there...and you weren't kidding about getting that nose up off the line!
Thread
Thread Starter
Forum
Replies
Last Post






