Been a minute since I've posted.....
Thread Starter
Supreme Member
iTrader: (5)
Joined: Jan 2002
Posts: 13,622
Likes: 5
From: Orland Park, IL
Car: 1984 Z28
Engine: SLOW carbed ls
Transmission: TH400 with brake, 8" PTC converter
Axle/Gears: moser 9" 4.11
Been a minute since I've posted.....
Working on an AEI motor plate install currently.
Moderator
Joined: Jul 1999
Posts: 17,274
Likes: 171
From: 51°N 114°W, 3500'
Car: 87 IROC L98
Engine: 588 Alcohol BBC
Transmission: Powerglide
Axle/Gears: Ford 9"/31 spline spool/4.86
Re: Been a minute since I've posted.....
That motor plate looks like it's 1/2" thick. I made my own from 3/8" thick plate.
Thread Starter
Supreme Member
iTrader: (5)
Joined: Jan 2002
Posts: 13,622
Likes: 5
From: Orland Park, IL
Car: 1984 Z28
Engine: SLOW carbed ls
Transmission: TH400 with brake, 8" PTC converter
Axle/Gears: moser 9" 4.11
Re: Been a minute since I've posted.....
Yes it's the upgraded half inch plate, rated at 2000hp. Bought it off jesasaurusrex on here. He ended up not building an ls combo. Certainly a stout piece
Joined: Jun 2002
Posts: 13,576
Likes: 30
From: Harford County, MD
Car: camaro sportcoupe
Engine: 7.0L
Transmission: G-Force GF5R
Axle/Gears: Moser 9"
Re: Been a minute since I've posted.....
when small blocks under 400 inches have more ***** than 600" big blocks, they need thick plates.
Senior Member
iTrader: (2)
Joined: Jan 2003
Posts: 721
Likes: 2
From: MN
Car: 1982 Camaro
Engine: 555 BBC
Transmission: TSI Glide
Axle/Gears: Aluminum Moser 3.89
Thread
Thread Starter
Forum
Replies
Last Post