LOOKING FOR A STOCK 400 BLOCK IF ITS .30 OVER AND READY TO GO A PLUS PREFFER TO STAY IN NORTHERN JERESY BUT NOT ALWAYS THE CASE EMAIL ME thecamarokid468@yahoo.com

 

I have a race ready 413 that is complete with hypertec pistons and x rods and crank. I live in GA though so that would be the prob. I would let it go for fairly cheap though, just let me know.

 

I've got a 406 short block still sitting at Canton Automotive, ready for your head choice, The reciepts are $2100, These guys campaign in the 406 truck class and win all over the country so I know its good.. If you let them put heads on it, they will guarantee their work, Block was hot tanked, magged, bored, line bored, crank ten under, every thing else new. Rods resized, new CR flat tops.. I put a 268 RV cam in it for intended marine use, deal fell thru, I have a brand new set of 76cc heads from GM that were drilled from the factory with the steam holes, then had 3-angle valve job done . everything on heads is factory new. $400 on the pair. Valves are 1.94/1.5" >.550 lift springs, 3/8 studs- castings are 3973493,Same as the 487's except with steam holes. I can deliver . BOB 330-806-6458

 

pm's and emails sent

 

i've got a 400 out of a 70 el camino. its fresh 30 over, new pistons, comp cam, double roller timing chain. heads are bare (magged and tanked) but no valves or springs. 700.00 plus shipping from bakersfield, ca 93314. ron09517@aol.com

 

email sent

 

I have a pontiac 400 if interested, its from a 71 Firebird Ram Air 4