Would it be safe to run NOS on a 383 stroker LT1. Right now i just pulled the LO3 305 TBI. I have just purchased a 95 LT1 with 6 speed transmission. I decided to rebuild it and stroke it to a 383. I am putting a cam and shaving the heads and port and polishing the heads also. How high of compression can i put it up to and be able to run NOS on it. As you can tell, i am trying to be able to pull up the front end with about $1000 in suspension. Can someone help me with the engine i am trying to build or any feedback you have. Thanks

 

Of course you can, NOS likes compression , as far as the heads, get a quality ported set, heres some that people have been getting very good results with http://63.96.253.179/SkarodoM/heads/...SProducts.html
and the pricing isnt half bad either.

William (Dr. Mudge) rolled an SAE Corrected 412rwhp with the following.


122,000 Mile Stock Shortblock
Our LT1 Cylinder Head Package
Our Custom Hydraulic Roller Grind
SLP Shorties
Stock Clutch
CSI Electric WP
Cutout on stock 2.75" exhaust
58mm BBK Throttlebody
CA Oxygenated 91octane Pump Gas