Hi, I'm wondering if this could be the right selection for my Eaton m112 LT1 engine

click here


If not what rods and pistons you recommend to use , my setup has a water to air intercooler and I'm looking for at least 450 hp

 

They dont seem to show the volume of the dish, but they look like they would work decent, you'll need some pretty big dish tops to bring the compression down enough to run any serious boost without harm.

 

what dish size should i be looking for ? Also, I'm a mechinist student, Can I mill out the dish and get it bigger, do piston have enough meat ?

 

www.racenet.net has a set in the 93-97 camaro catalog that state with their 24cc dish will give you 9:1 with a 58cc head, most LT1 stock heads seem to be under the 58 they're supposed to be, i'd say go for somewhere between that 24 and as much as 31 depending on how much you plan to push it.