Degreeeing a blower cam/
Thread Starter
Senior Member
iTrader: (3)
Joined: Jul 1999
Posts: 844
Likes: 0
From: Long Island, NY
Car: 1987 GTA
Engine: 645hp/656 ft lb Blown 383
Transmission: 700-R4 3,000 stall
Axle/Gears: 3.55 moser 12-bolt
Degreeeing a blower cam/
I would post this on the other board,..but I only go to the power adders section, and i know most of you guys... Anyway,...Does anyone have a set of directions they can post or something on degreeing a cam. I assembled the rest of the motor before i went on my honeymoon, and it assembled easily. Time to install the cam...I've never degreed a cam before,...so this part I have no clue. Thanks -Justin
Senior Member
Joined: Oct 2002
Posts: 696
Likes: 0
From: near seattle
You could purchase teh timming chain kit with teh notches in it which allows for you to degree the cam. BUT you should verify the cam with a deg. wheel to make sure your cam is where you want it.
Thread Starter
Senior Member
iTrader: (3)
Joined: Jul 1999
Posts: 844
Likes: 0
From: Long Island, NY
Car: 1987 GTA
Engine: 645hp/656 ft lb Blown 383
Transmission: 700-R4 3,000 stall
Axle/Gears: 3.55 moser 12-bolt
hmmn, can't open this,...I think i need Adobe,.. but where do i save it to on my cpu. thansk
Thread
Thread Starter
Forum
Replies
Last Post
codeysabatini
Engine/Drivetrain/Suspension Parts for Sale
5
Nov 10, 2015 04:07 PM
buckeyecelt
Tech / General Engine
3
Sep 24, 2015 05:50 AM
