P1SC belt help needed
Thread Starter
Supreme Member
iTrader: (8)
Joined: Jan 2000
Posts: 3,968
Likes: 1
From: Macedonia ,OH
Car: Formula
Engine: 6.0 LSX
Transmission: 4L60E
Axle/Gears: 9 Bolt 3:27
P1SC belt help needed
we installed everyting but it seems the K080645 is way too small. We got everything in place like ATI says and even looked at ******* pic for verification. I mean I accually have the 1 idler pulley off and the tentioner pulley off and it doesnt even seem close to coming on. Is there a way to get this on?
Supreme Member
iTrader: (7)
Joined: Jul 2000
Posts: 2,047
Likes: 2
From: Prince George, BC, Canada
Car: 89 GTA
Engine: 5.7L Supercharged
Transmission: T-56
Axle/Gears: Moser 9" 3.70
What size is the blower pulley?
On my D1SC with a 4" blower pulley 7.65" crank I use a 65" belt and I have to take off the blower pulley wrap the belt around it first then install it like that with little bit of force.
On my D1SC with a 4" blower pulley 7.65" crank I use a 65" belt and I have to take off the blower pulley wrap the belt around it first then install it like that with little bit of force.
Thread Starter
Supreme Member
iTrader: (8)
Joined: Jan 2000
Posts: 3,968
Likes: 1
From: Macedonia ,OH
Car: Formula
Engine: 6.0 LSX
Transmission: 4L60E
Axle/Gears: 9 Bolt 3:27
Thanks for the tip. I took the headunit off and put belt on then put the headunit back on. Worked perfect. Thanks!
Thread
Thread Starter
Forum
Replies
Last Post
1992 Trans Am
History / Originality
27
May 10, 2023 07:19 PM