I'm getting to where I need to start thinking about my BOV, and it's placement. I've been looking around and got some pretty good ideas of which one to get, but not too exactly sure. I just want the easiest one to install, weld onto my inlet pipe, not nesecarily the best. But here's my question.

The bov gets a vacuum/boost line from the manifold, so I was thinking, could I use the line that is currently used for pcv purposes? the one that goes back to the valve cover? Would that be the same line that the Bov would need? I would just install a breather on the valve cover anyhow. That's my thoughts.