mods
Thread Starter
Member
Joined: Mar 2003
Posts: 225
Likes: 0
From: Concordia, Missouri
Car: 91 Firebird
Engine: 305 TBI
Transmission: 700r4
mods
what about a section just for origanal mods something you dont see all the time. A place to swap home made mods? just curious 
TGO Supporter
Joined: Aug 1999
Posts: 14,811
Likes: 1
From: Jackson County
it's been sujested before. fabrication and machining, or something along those lines. write the admins at webmaster@thirdgen.org
maybe it'll happen
maybe it'll happen
TGO Supporter
Joined: Jul 2002
Posts: 3,680
Likes: 7
From: Dirty Jersey
Mark, stop post-whoring dammit!!!
I'm all for a fabrication "section" of the site, but I'm not sure that another forum would be effective with this. It would have to be something like a listing of mods, a "tech article" for each listing (or more than one), and an area below it for people to make comments, suggestions, etc etc. It would take a lot of administrating to do that on a forum.
Maybe if it was a forum where posters would submit their article to a moderator, and they would post it up if it's admissible, under the correct heading (interior, engine, lighting, blah blah blah). That might work.
I'm all for a fabrication "section" of the site, but I'm not sure that another forum would be effective with this. It would have to be something like a listing of mods, a "tech article" for each listing (or more than one), and an area below it for people to make comments, suggestions, etc etc. It would take a lot of administrating to do that on a forum.
Maybe if it was a forum where posters would submit their article to a moderator, and they would post it up if it's admissible, under the correct heading (interior, engine, lighting, blah blah blah). That might work.
Thread
Thread Starter
Forum
Replies
Last Post