edlebrock
Thread Starter
Member
Joined: Jan 2004
Posts: 107
Likes: 0
From: Houston TX
Car: 91 firebird TBI
Engine: Three SLow Five. LO3
Transmission: MAN 5 SPD B0RG WARNER, 77MM, 2.95
edlebrock
Will the performer rpm set up fit on a 305 tbi? i was wondering if i could just do that along with port andpolishing and headers and etc etc. i know about the other stuff im just not to sure about the rpm setup.
i am considering this option because most of the Ls1 i have found are either way hot (stolen) or way expensive.
i am considering this option because most of the Ls1 i have found are either way hot (stolen) or way expensive.
Supreme Member
Joined: Jun 2003
Posts: 1,521
Likes: 0
From: Cypress,Tx
Car: 89 Camaro RS
Engine: 350 carbed now
Transmission: World Class T5
Axle/Gears: Peg Leg w/ 3.73's
The performer RPM intake will not fit your heads with out some modifications. Because you have center bolt heads.But instead of porting and polishing your heads(L03 heads are junk) just get a good set of vortec heads and a performer RPM manifold to match. If you have any other questions in regards to TBI go to the tbi boards the guys over there know there stuff.Good Luck.
Thread
Thread Starter
Forum
Replies
Last Post
theshackle
Tech / General Engine
4
Mar 5, 2017 06:37 PM