Anyone have a motor and/or tranny sitting around that you might want to sell?

Email me if you do jramosjr@houston.rr.com

 

Have most of a 350 shortblock in my garage. Located in San Antonio. Its a older 2pc rear main. I'd let it go pretty cheap if you picked it up.

Email me if interested.

 

Well I have a 350 Vortec 4bolt main. I just wanted to see if anyone had a temporary one for me already assembled ready to go. High mileage or low, just temporary..

 

I have a high milage 305 that I'm told runs OK, but burns oil. Complete except no inake. No tranny either.

$50.00


It's in SW Houston.

 

I will have a 350TPI w/ T-5 Tranny and ECM

The motor has 120k or so miles on it, unknown number of miles on the tranny.

It runs, but If I was going to take the time to put it in a car, I would rebuild both the engine and tranny. Its not out of the car yet, probably going to be a month or two.

 

I got a "82" 305. Itz blown but it could be rebult! Also got 305 flywheel $125(already posted under 305 flywheel)

 

I've a 2-piece rear 4-bolt 350 that's been punched .030 over.
I've also got a 400 crank that has recently been turned.
355 block + 400 crank = 383 stroker