I just dropped my camaro back on its feet after doing suspension work to it now it sits like 1 inch lower on the driver side then the passenger side. Any Ideas?????? I am stumped.

Here is what I have.
Lakewood LCA's and ADJ. Panhard bar
Drop Zone Lowering springs
New shocks and struts
Iroc anti sway bars

 

Right front spring not indexed properly or isolator missing from left front

Look at the control arm, at the spring pocket; you'll see 2 little holes about ¼" diameter about ¾" apart; the spring is supposed to be rotated such that the end of is between them.

There's a rubber pad about ½" thick that goes on top of the spring; if one side has it and the other doesn't, it will produce this result.

 

yep..I guess thats right...
after I replaced my springs I didnt know about indexing...and when I put the fronts in my right side the bottom of the spring is splitting the first hole and the drivers side is in between the 2 holes and my car sits about 1/4 lower on the drivers side. I need to take them both out and Im going to halfway cover the second hole on both...

that should put me about the way I want it to sit on the front...

 

Mine sits uneven because I'm certain some punk from around here pushed it off of the jackstands.

 

I noticed that my springs were not seated right. Is there a way to "spin" them without taking everything apart? Maybe removing the top strut mount to release some tension. I really don't want to take everything apart!