Tracking & Alignment
Thread Starter
Junior Member
Joined: Jun 2003
Posts: 1
Likes: 0
Tracking & Alignment
Hi,
Can anyone help? I have a 1997 Trans-am ram air WS6 which i have just bought new tyres for.The original tyres on the front were wearing abnormally on the outer edges,so much so that it was getting down to the canvas in places with reasonable tread in the middle,i check the pressures regularly and they are to the book always.
I think the tracking and alignment might need to be checked but i wondered if anyone could tell me what the necessary readings should be for the front or tell me where i can find out because they do not list any figures in the hand book.
any help would be appreciated.
Can anyone help? I have a 1997 Trans-am ram air WS6 which i have just bought new tyres for.The original tyres on the front were wearing abnormally on the outer edges,so much so that it was getting down to the canvas in places with reasonable tread in the middle,i check the pressures regularly and they are to the book always.
I think the tracking and alignment might need to be checked but i wondered if anyone could tell me what the necessary readings should be for the front or tell me where i can find out because they do not list any figures in the hand book.
any help would be appreciated.
Supreme Member
Joined: Oct 2001
Posts: 1,392
Likes: 4
From: orlando, fl usa
Car: 1986 pontiac TA
Engine: 360 HSR
Transmission: 700r4 3300 yank converter
Axle/Gears: 3.27 9 bolt
specs are:
camber --- 0.30 +/- 0.50
caster ----- 4.80 +/- 0.50
toe -------- 0.00 +/- 0.20
camber --- 0.30 +/- 0.50
caster ----- 4.80 +/- 0.50
toe -------- 0.00 +/- 0.20
Thread
Thread Starter
Forum
Replies
Last Post