suspension question?
Thread Starter
Junior Member
Joined: May 2003
Posts: 35
Likes: 0
suspension question?
i have an 84 trans am that i am currently building and and i have ordered several suspension parts for it and was wondering what else i should get or if this should be good?
50' wide ladder bars
1' drop front and back springs eibach
sub frame connectors
steering brace
50' wide ladder bars
1' drop front and back springs eibach
sub frame connectors
steering brace
Supreme Member
iTrader: (1)
Joined: Jul 2004
Posts: 10,763
Likes: 4
From: Calgary, AB, Canada
Car: 1982 Trans-Am
Engine: 355 w/ ported 416s
Transmission: T10, hurst shifter
Axle/Gears: 10 bolt, true-trac, 3.73
Rear control arm relocation brackets and boxed/new control arms. Poly bushings all around as well.
That's my opinion at least.
That's my opinion at least.
Supreme Member
iTrader: (1)
Joined: Jul 2004
Posts: 10,763
Likes: 4
From: Calgary, AB, Canada
Car: 1982 Trans-Am
Engine: 355 w/ ported 416s
Transmission: T10, hurst shifter
Axle/Gears: 10 bolt, true-trac, 3.73
Yea, and 50' ladder bars...
I'm guessing those foot symbols were supposed to be inch symbols ( " ) instead...
What are you doing with the car anyway? Just drag race, or...?
Drop springs and ladder bars seem to be contradictory in my opinion.... Depends on what you want to do with the car. However I think new poly bushings all around are a very good investment.
I'm guessing those foot symbols were supposed to be inch symbols ( " ) instead...
What are you doing with the car anyway? Just drag race, or...?
Drop springs and ladder bars seem to be contradictory in my opinion.... Depends on what you want to do with the car. However I think new poly bushings all around are a very good investment.
Thread
Thread Starter
Forum
Replies
Last Post