Bump Stop Question
Thread Starter
Junior Member
Joined: Oct 2006
Posts: 50
Likes: 0
From: long island ny
Car: 1989 Trans Am
Engine: 305
Transmission: 700r4
Axle/Gears: 3:42
Bump Stop Question
i am in need of new front and rear bumpstop. my question is are the polyurthene bump stops better than the stock rubber? it just seems rubber would provide more cushion and absorb more impact. also was wondering if anyone had the part numbers for bumpstop preferably something that would work good with a sportline drop if not i dont mind trimming them. Thanks
Supreme Member
iTrader: (1)
Joined: Feb 2004
Posts: 1,040
Likes: 1
From: High plains of NM
Car: 89 Firebird
Engine: L98
Transmission: T-56
Axle/Gears: 3.73
Re: Bump Stop Question
You can get the front bump stops any where just about.
The only place I have been able to find the rear bump stops is the dealer. The rear bump stops the dealer sells now arn't any thing like the orginal factory bump stops. They are bigger and I think they are made of Polyurthene too.
You may need to trim the dealership bump stops if you go with those.
The only place I have been able to find the rear bump stops is the dealer. The rear bump stops the dealer sells now arn't any thing like the orginal factory bump stops. They are bigger and I think they are made of Polyurthene too.
You may need to trim the dealership bump stops if you go with those.
Thread
Thread Starter
Forum
Replies
Last Post
1992 Trans Am
History / Originality
27
May 10, 2023 07:19 PM





