S&W 8-point
Thread Starter
Joined: Dec 2007
Posts: 1,924
Likes: 12
From: Minnesota
Car: 84 camaro, 88 trans am, 98 camaro
Engine: Modded , stock, LSX modded
Transmission: 700r4, 700r4, t-56
Axle/Gears: 327, 308, 373
S&W 8-point
The kit its been laying around in my garage forever.
my cars interior is currently striped, im wounding if anyone on here had some pics they can post up with the stock interior in the car so i can get a genera idea of what it would look like installed
my cars interior is currently striped, im wounding if anyone on here had some pics they can post up with the stock interior in the car so i can get a genera idea of what it would look like installed
Joined: Feb 2007
Posts: 4,767
Likes: 63
From: Trumbull CT
Car: 87 TA clone
Engine: 70/70 Turbo 5.3 LS
Transmission: bullet proof 2004R
Axle/Gears: ford 8.8, 3.55 gears
Re: S&W 8-point
just posted a thread i just installed a 6pt comp engineering cage. havent put the carpet down yet.
Joined: Jan 2004
Posts: 1,761
Likes: 4
From: The "D"
Car: A Portly 85 Z28
Engine: 4.530 X 4.250 BBC
Transmission: under rated for this application
Axle/Gears: also under rated
Re: S&W 8-point
few shots of mine, obviously the plastics took a beating, but it is adrag car and I wanted the bar where it would benefit me the most.
Joined: Feb 2007
Posts: 4,767
Likes: 63
From: Trumbull CT
Car: 87 TA clone
Engine: 70/70 Turbo 5.3 LS
Transmission: bullet proof 2004R
Axle/Gears: ford 8.8, 3.55 gears
Re: S&W 8-point
nice cage greezemonkey. is that a 10pt? where did u weld the rear strut bars to above the tank? they look alil far back.
this is where i put mine, all the other steel on the rear above the tank and down is thin like 22 gauge.
https://www.thirdgen.org/forums/susp...-cage-tig.html
this is where i put mine, all the other steel on the rear above the tank and down is thin like 22 gauge.
https://www.thirdgen.org/forums/susp...-cage-tig.html
Thread
Thread Starter
Forum
Replies
Last Post