More 1LE Questions,,,,,,,
Thread Starter
Junior Member
Joined: Jun 2000
Posts: 6
Likes: 0
From: Fullerton, CA
More 1LE Questions,,,,,,,
So I've read the postings on the 1LE conversion and just have one question, will the GM bracket, bolts, nuts and the AutoZone rotors and hubs fit my 92 Z28? I don't want to go with 1le spindles.
Thanks
------------------
1992 Z28 116K miles - early mods: airfoil, plug wires, ADS chip, Flowmaster muffler
Current mods: Edelbrock intake, Accel AFR, SLP Siamese Runners
Future mods: ??????
Thanks
------------------
1992 Z28 116K miles - early mods: airfoil, plug wires, ADS chip, Flowmaster muffler
Current mods: Edelbrock intake, Accel AFR, SLP Siamese Runners
Future mods: ??????
Supreme Member
iTrader: (10)
Joined: Jul 1999
Posts: 1,780
Likes: 2
From: Fla
Car: 90 IROC
Engine: 406
Transmission: GMPP 93/4L60
Axle/Gears: 9 bolt 3.27
Yes they will...the 89-92 stock spindles are the ones to have because they are thicker. But you will have to cut the ears off and drill and tap a few holes. Other wise you will need the 1LE spindles.
On the third page of this board There is a post under my name about the gulstrand brackets. Karl Hunter explains the swap in more detail. He has done a few of these so he knows what he is talking about.
------------------
Black 90 IROC, L98, A4, 323 gear. SuperRamed 406 in the works!
[This message has been edited by MikeH (edited December 23, 2000).]
On the third page of this board There is a post under my name about the gulstrand brackets. Karl Hunter explains the swap in more detail. He has done a few of these so he knows what he is talking about.
------------------
Black 90 IROC, L98, A4, 323 gear. SuperRamed 406 in the works!
[This message has been edited by MikeH (edited December 23, 2000).]
Thread
Thread Starter
Forum
Replies
Last Post